Sentence examples for change the mode of from inspiring English sources
This kind of exam requires us as teachers to change the mode of teaching to enable the pupils to know how to tackle the exams following the new approach.
The obtained bilayer arrangements can change the signs of intermolecular interactions, which in turn change the mode of coupled deformations and the patterning characteristics resulting in adjustable properties.
Faced with upheavals in entrepreneurial environment, economic policy and labor factor dramatically change the mode of production; immigrant enterprises from Wenzhou are confronted with development imprisonment.
Out of all subcarriers violating (59), we only change the mode of the subcarrier k which gives rise to the largest rate increase when switched to the direct mode.
As such they are a mere example of the policy challenge that rests upon many states' shoulders to decide on whether or not change the mode of legal governance for establishing heat infrastructures from a bottom-up perspective.17.17
In another investigation, Alfarabi et al. (1994b) examined the feasibility of utilizing GFRP plates for shear strengthening, using configurations such as plates, wings, and I-jacket patterns, and observed that only I-jacket shape could change the mode of failure to flexural failure.
The high penetration of wind energy has the potential to change the modes of instability in power systems [7].
The addition of surfactants changed the mode of interfacial instability significantly but in different ways: SDS enhanced the mass transfer and Triton X-100 reduced the extraction fraction.
It was observed that conditioning changed the mode of failure of some of the tested beams as compared to that of their unconditioned counterparts.
Based on failure patterns of all GFRP outdoor environment series, it can be summarised that exposed condition changed the mode of failure from very thick concrete layer to very thin concrete layer attached to GFRP coupon compared to control series.
It was found that decreasing the stirrup spacing from 150 mm to 75 mm increased the bond capacity and changed the mode of failure under monotonic loading from splitting to pullout.
