Sentence examples for cd specimens from inspiring English sources

The average IVD cross-sectional areas were 2.45 cm for the CD specimens and 3.10 cm for the NCD specimens.

Based on preliminary tests conducted in three additional CD specimens (not included in this study), maximum moments of newton meters were predetermined for flexion and extension, ±3 Nm for lateral bending, and ±4.5 Nm for axial rotation [ 24, 25].

c Specimens W25 and W25V.

ZrC + C specimens in the form of a thin layer (4.9 μm) sputtered on isolating substrates by magnetron sputtering technique were used.

Based on the results of Table 2, the T-SS, EP-C, TSZ w/EP-C and A-C specimens produced the lowest theoretical steel loss indices.

(A-C) Specimens from Xiao-Liu-Qiu Xiao-Liu-Qiu Xiao-Liu-Qiu Islandr southerndifferenTaiwan of the vinlousummerl portion (arrowshowingdifferent densize of the glabrous upper portion.

At a drift level of ±5%, both the code based ductile specimens (Type A) showed a strength deterioration of 30% after the third cycle whereas Type B and Type C specimens experienced 10%and20%0%, respectively.

The strength of these two anchor sizes was determined from testing of specimens in group C (Specimens CII-25-1.3-5 and CII-25-1.9-10), consisting of 254 mm wide sheets attached to the concrete blocks only through FRP anchors.

After 60 days, the T-SS, EP-C, TSZ w/EP-C, A-C, TSZ, and EA-A w/A-C specimens continued to display a decrease in corrosion current with respect to time.

Group A specimens were only bonded, group B had combinations of bonded regions and anchors of different sizes and patterns, and sheets in group C specimens were unbonded and attached solely using FRP anchors.

c Specimens fixed by GA solution including ruthenium red (RR) or d tannic acid (TA) unmasks further textured extracellular matrix at the interface and basal lamina of a CD ampulla, which is labeled by a cross.