The significance of this process is the most important at the end of the melting season when temperatures below 0 °C occur on glaciers (resulting in a slowdown of melting of ice and snow and a smaller recharge of the river by the water from the glaciers) while the flow of groundwater is still active, causing a relatively higher contribution of groundwater to the total river discharge.
About 80 mol% CyMA in the copolymer network causes a relatively high dissociation degree of LiCF3SO3 (≈50%), cationic transference numbers t+≈0.5 and an anodic stability up to 5 V.
The decision was mainly based on two phase II trials where Bevacizumab caused a relatively high radiographic response rate and prolonged progression-free survival of the patients compared to historical controls [9], [10].
This can cause a relatively high fraction of deletions to be lethal in the first interval.
Relatively few nucleotide changes cause a relatively high number of amino acid changes, indicating that these regions are selected to diversify.
A large frontal area causes a relatively high drag, whereas a slim and streamlined body allows oncoming air molecules to flow past more easily resulting in low drag.
These SNPs cause a relatively high ratio of non-synonymous mutations in genes; for example, 9680 genes were found with (≧10) non-synonymous SNPs.
This is most likely due to the fact that MCF7 cells exhibit a constitutively active PI3 kinase which causes a relatively high basal AKT activity (as seen in the starved cells in Figure 5A).
74 GLP-1 agonists are associated with a low risk of hypoglycemia and modest weight loss, but cause a relatively high incidence of gastrointestinal disturbances, including nausea, vomiting, and diarrhea.
It is not associated with hypoglycemia but causes a relatively high frequency of gastrointestinal disturbances, with 30 45% of treated patients experiencing one or more episodes of nausea, vomiting, or diarrhea (78– 81).
This effect can be explained by the high intensity of the ions outside the core region, which causes a relatively higher sputtering of the material on the sides of the walls, thus resulting in the creation of slopes.
