Sentence examples for catalyst volume from inspiring English sources

A catalytic reaction rate can be based on catalyst volume, surface, or mass.

Kinetic studies typically deal with initial rates whereas most of the catalyst volume in industrial reactors work close to equilibrium.

The cycled reactor is shown to give a better conversion for the same catalyst volume.

The simulation results show that a micro-structured reactor exhibits the highest productivity per unit of catalyst volume followed by slurry bubble column reactor and monolith reactor.

Indeed, the operating parameters studied in this research work were the initial concentration of malathion, H2O2 catalyst volume and the pH of the solution.

However, often it is a challenge to satisfy the requirement for sufficient catalyst volume for the reaction while providing the interfacial area needed for mass transfer.

It implies that the synthesis method significantly influences the specific surface area and pore volume of the catalysts.

It is found that the growth of individual CNTs differs from that of CNT forests grown from unpatterned catalyst films, an effect that can be attributed to the difference in catalyst volumes.

But, although such near-optimum operation conditions may lead to higher reaction rates and, thus, lower catalyst volumes could be required, it is found that the optimal design of the ammonia loop is rather determined by the performance of each component and their interdependencies.

Hydrocarbon synthesis rates (per catalyst mass or volume) on Fe Zn Cu K catalysts prepared by the methods described here were similar to those on representative Co-based catalysts at these conditions.

According to the Box Behnken design, the temperature, amount of catalyst, extractant volume, and reaction time were chosen as four important factors with three levels for the dehydration step.