Sentence examples for casting cavity from inspiring English sources

If cavities are intended to be left in the casting for example, to form a hollow part sand shapes called cores are made and suspended in the casting cavity before the metal is poured.

The technological process was based on covering the casting mold cavity with coatings containing substrates of the TiC formation.

A mold is created from the wax form, and then "molten precious metal is cast into the mold cavity".

This study describes an indirect 3DP protocol, where molds are printed and the final materials are cast into the mold cavity to overcome the limitations of the direct technique.

The 3D models of the casting (corresponding to the mold cavity) and the ladle are cut into slices to obtain the sectional information for the iterative calculation.

Under casting conditions, failure to fill the mould cavity results not from high viscosity but from premature solidification.

The most critical step in casting process is the solidification of molten metal in prepared mould cavity, because this is time where the defects like volumetric shrinkage, porosity, blowholes occurs and affects the quality of casting.

The mold must be strong enough to resist the pressure of the molten metal and sufficiently permeable to permit the escape of air and other gases from the mold cavity; otherwise, they would remain as holes in the casting.

Once the mold cavity is filled, the pressure is maintained until the casting solidifies.

Die casting is a metal casting process that is characterized by forcing molten metal under high pressure into a mold cavity, which is machined into two hardened tool steel or coated dies.

Die casting is a metal casting process that is characterized by forcing molten metal under high pressure into a mold cavity.