Sentence examples for cast cylinder from inspiring English sources

The cast cylinder was electro-slag remelted (ESR) for obtaining clean steel.

The aim of this research was to study a complex A356 gravity die cast cylinder head, in order to verify the range of variability of the main microstructural parameters and tensile properties, using specimens directly machined from the casting.

The synthesis of the finely mixed α-Fe+Fe3C+graphite alloys having good mechanical properties by crystallization of the new amorphous alloy in the melt-spun ribbon and cast cylinder forms is encouraging for the future development of a new Fe-based high-strength and high-ductility material.

Melt-spun ribbons and copper-mold cast cylinders of (Ti0.5Cu0.23Ni0.2Sn0.07 100−xMox bulk glass-forming alloys are prepared.

The earliest steam engines suffered from the imprecision of early machine tools, and the large cast cylinders of the engines often were bored inaccurately by machines powered by waterwheels and originally designed to bore cannon.

Both cast cylinders and cores were tested, showing that the aggregate type had an effect on the splitting tensile strength versus compressive strength relationship.

The addition of a small amount (0.4 mass%) of B to a commercial FC20 cast iron was found to cause the formation of an amorphous phase in melt-spun ribbon and cast cylinders with a diameter of up to 0.5 mm.

Phillip Sherrell, 39, left a job making cabinets in nearby Birmingham to take a job in August casting cylinder heads for the Odyssey.

The results also demonstrate that the splitting tensile strength versus compressive strength curve for the core specimens was steeper compared to the curve representing all specimens, indicating that the equation for casted cylinder specimens is underestimating the core splitting tensile strength by 7 13% for compressive strengths between 10 and 20 MPa (1450 2900 psi), respectively.

Pour the Acrylamide solution into the casting cylinder.

Slowly lower the snap cap vial, tubes and funnel combination into the casting cylinder so that the water entering through the lower hole in the funnel lays over the gel solution.