Sentence examples for carbonated surface from inspiring English sources

Environmental Scanning Electron Microscopy (SEM), Fourier Transform Infrared (FT-IR) Spectroscopy and thermogravimetric analysis (TGA) results indicated that calcium silicate hydrate with low Ca/Si ratio and CaCO3 were the products in the carbonated surface layer.

Through interfacial and cell-mediated reactions, bioactive glass develops a calcium-deficient, carbonated phosphate surface layer that allows it to chemically bond to host bone (Hench [1997 , 1998 1999]; Hench et al. [1971]; Hench and Wilson [1993]; Pereira et al. [1994]; Wilson et al. [1981]).

The collagen and carbonated HA (lath-like surface) were successfully immobilized on the polydopamine film with less agglomeration as the immersion time in the collagen solution increased.

While nesquehonite was observed to transform into an amorphous phase during hot dry episodes, evidences are presented on nesquehonite transformation into hydromagnesite and dypingite on the surface of already carbonated layers during long-term contacts under occasional wetting and drying episodes.

To this end, Spence has helped Martin wire up some of his plates so they can play the sound of carbonated bubbles floating to the surface of a G&T while the diners savour the frozen version.

From this result of actual outdoor exposure test, the surface finish material which has not carbonated shows as if carbonation has occurred in Fig. 10.

In this work, a series of USACs with specific surface areas up to 3633 m2/g were prepared in two steps: hydrothermal carbonization (200 °C) of carbonated beverages (CBs) and further thermal treatment in nitrogen (600 1000 °C).

A range of characterization techniques was applied to confirm the deposition of Hydroxyl carbonated apatite (HCA) deposition on the surface of HT-15%Dio scaffold following 7 days in SBF.

Carbonated drinks contain carbon dioxide gas.

The calcium phosphate deposit on titania plates was characterized as calcium-deficient carbonated hydroxyapatite using XRD, FTIR and FE-SEM, whereas the deposit on non-porous, non-functionalized titanium surfaces was characterized as carbonated apatite.

The results showed that MOF-5 was fully carbonated at 900 °C, having the highest specific surface area of 1563.09 m2 g−1 and the largest pore volume of 1.07 cm3 g−1.07