Sentence examples for capacity of reactor from inspiring English sources

Fig. 1 Schematic representation of the airlift bioreactor Table 1 Table showing the dimensions of the airlift bioreactor Parameters Volumetric capacity of reactor Column diameter Column height Ungassed liquid height Draft tube height Draft tube diameter Height of draft tube above the fermenter base Single sparger hole diameter Dimensions 2.0 l 60 mm 650 mm 150 mm 350 mm 40 mm 80 mm 1 mm.

This paper investigates the effects of nuclear accidents on energy policy with the help of a panel dataset of 31 countries from 1965 to 2009, using annual data on the capacity of reactor construction starts, as well as the timing of three nuclear accidents scaled five or higher on the International Nuclear and Radiological Event Scale.

In this mixed-integer linear programming (MILP) model, integer variables are utilized to determine the discrete capacity of reactors.

A higher growth rate was obtained in pilot-scale reactor (0.430 1/dat) at a rate comparing to a column reactor (0.299 1/day), although the ratio A/V of 10 m3 reactor was 22 times smaller than the capacity of the reactor with the capacity 0.5 m3.

The power produced by the reactor core spiked to at least 10 times the rated capacity of the reactor.

The heat capacity of the reactor content is calculated from the amplitudes and the phase shifts of the reactor temperature, of the electrical heater and of the cooling rate when forced temperature oscillations are applied.

Higher NaOH concentration significantly increased reaction rate and production capacity of the reactor.

Inappropriate stirrer speed runs dramatically decreased the production capacity of the reactor.

Ranges of variation of parameters were determined, considering the capacity of the reactor system and the obtained results from the literature.

Oxygen transfer efficiency and oxygenation capacity of the reactor varied from 12 to 22.5% and from 0.2 to 1.8 kgO2kW−1, respectively.

The optimum operating conditions, best ammonia feed configuration (side or central) and capacity of the reactor to deal with feed concentration disturbances is analysed.