Sentence examples for calculation error for from inspiring English sources

Furthermore, calculation error for the dew point pressure was measured to be 0.001.

The paper shows results of computing test efficiency and the maximum calculation error for a trajectory generated from G-codes.

On the other, SE results exist at a certain degree of calculation error for ~0.3 nm, which could lead to a considerable calculation error to growth rate (~0.1 Å/cycle when ALD cycles are below 50).

Some minor calculation errors for four-way multibranch loops were corrected, however (see Supporting Information).

To take this into account, we estimated, for each bundle independently, average calculation errors for Mahalanobis distances between infants and adults.

If (f^{std} ( cdot )) is a nonlinear function, the power deviation caused by speed deviations cannot be offset, thus neglecting spatial dispersion of the wind speeds will lead to the calculation error of total wind power for a wind farm.

Table 7 VAR calculation error ratio for TSE total index at confidence interval 99%%   Monte Carlo Halton sequence Sobol sequence Error ratio 0.05 0.05 0.05.

With instrumental or calculation error and other possibilities accounted for and eliminated as possible sources of the readings, Borra and Trottier suggest that the signals may possibly have come from extraterrestrial intelligence trying to alert humans to their existence.

In this paper, rate calculation, error probability analysis and code design for DPC are investigated from a practical point-of-view.

The proposed "segmented" model shows more precise than the "non-segmented" model by the comparison of simulated and experimental temperature distribution and variation of an ultra-thin micro heat pipe (UMHP) battery pack, and has less calculation error to obtain dynamic thermal behavior for exact thermal design, management and control of heat pipe BTMSs.

We combined the algorithm for multiple-flow direction (MFD) used in the UCA method with the LS-TOOL (LS-TOOLSFD) algorithms, taking into account the calculation errors and cutoff conditions for distance, to obtain slope length and the LS factor.