Sentence examples for calculation differences in from inspiring English sources

In patients without further assessment of local control e.g. after development of distant spread, the date of the last information about the local status was used for calculation Differences in subgroups were tested for statistical significance by the log rank test.

According to this calculation, differences in the free energies of transfer of FC between coexisting rHDL are small, with the greatest differences existing for the transfer from the smallest to the largest rHDL; e.g., at 20 mol % FC, the free energy of transfer of FC from the smallest to the largest particle is approximately −1.2 kJ.

Depending on actual layer configuration and materials properties used in the calculations, differences in tensile stresses up to 3.6 times were observed.

The calculations (difference in reduction between control and treated cells) were done according to the recommendations of manufacturer (AbD Serotec).

Therefore, to extend the period of record of flux calculations, comparisons of calculations with differences in wind speed data were performed (Additional file 1).

An important factor interfering consistent calculation are differences in reservoir rock composition and their impact on fluid chemistry.

Genes that showed high expression in hyperplastic prostates by calculation of differences in mean expression level (Figure 1C), like Expi, Wfdc2, Tacstd2 (Trop2), Clu, Ppp1r1b, Sca-1 and CK19, were also found overexpressed by Significance Analysis of Microarray (SAM) (Figure 1D).

The same program was used for calculation of differences in cell surface expression of leukocyte antigens in the leukapheresis product.

The one-way ANOVA method was used for calculation of differences in expression levels between the TNM tumor stages (I-III) for LSD1, HDAC2 and SIRT1.

For the calculation of differences in pain scores per position, average, and the maximum pain score during the procedure will be calculated using an independent samples t-test.

We used R version 3.2.0 for forest plots and the calculation of differences in C statistics (DeLong method) and failure rates.