Sentence examples for calculated rupture from inspiring English sources

I and U denote the calculated rupture values and the strain energy densities (104 J/m3), respectively.

Seismicity is sampled for Fig. 2 from two gray dotted rectangle areas; the colored tick marks inside them represent calculated rupture front locations at each elapsed time shown by the colors assuming the diffusion coefficient D = 0.78 × 104 (refer to the text for the detail).

Since the rupture value is an important parameter to indicate the fracture development in the study area, comparison between the calculated rupture values and the observed core fracture density is informative to help analyze the reliability of the models (Figs. 13, 14).

The calculated spring constant k C can then be used to calculate rupture force, F, by F = k C CΔV. Δ V is the change in voltage detected by the photodiode just prior to and immediately after the rupture event.

We then calculated the rupture velocity for each subfault as the shortest on-fault distance from the hypocenter to the subfault divided by the rupture delay time.

The equivalent obstacle spacing for mobile dislocations is calculated from the rupture data and is comparable to the interparticle distance observed by transmission electron microscopy.

Elongation in maximum tensile force, calculated before construct rupture showed values of 5.95 mm (range 3.83 7.57 mm range) for the LGA group and 6.12 mm (range 4.68 7.51 mm) for the CGA group, which exceeds the maximum elongation obtained by Higuchi et al. (2010).

(4) Toughness is the energy absorbed by a fiber prior to rupture, calculated as the area under the stress strain curve divided by sample volume (initial cross-sectional x length of the fiber).

The burst pressure (BP mmHg) was calculated from the rupture test; using the same equivalence model used for the compliance, the pressure was derived from the ultimate tensile stress and the diameter was derived from the ultimate strain.

Therefore, in order to discover whether the Itozawa fault rupture triggered the Yunodake fault rupture, we calculated the effect of the static ΔCFF of the 2011 Tohoku earthquake on the Yunodake fault; the static ΔCFF was calculated based on Okada (1992) using the final slip distribution of the 2011 Tohoku earthquake (Kubo and Kakehi 2013).

Synthetics calculated from the estimated rupture process are compared with the observed data in Fig. 5.