Sentence examples for calculated diameters of from inspiring English sources
This correspondence is achieved with a high degree of certitude as only two SWNTs felt within the Raman resonance condition of our experiment, and the theoretically calculated diameters of these SWNTs, namely 0.84 and 0.69 nm, for (8,4) and (6,4), respectively, are very close to the experimentally measured values by AFM. Figure 3 AFM and Raman spectroscopy data analysis.
Table 1 Calculated diameters of Cu NPs as a function of heating temperature Temperature (°C) 700 800 900 1,100 Diameter (nm) 3.3 4.3.3.6 5.6.
The calculated diameters of LCP fibrils in the fibers were found to be in agreement with the measured values.
The inner diameters of these CNTs corresponded to the calculated diameters of Fe nanoparticles by assuming that all Fe ions contained in each pore are reduced to a single nanoparticle.
The calculated diameters of the zones of inhibition are tabulated in Table 3 and the zones were clearly observed from the Figure 3.
The formation of a halo of protein degradation, representative of protease secretion, was evaluated and the clearance index calculated (diameter of clearance zone / diameter of colony).
We calculated diameter of each ulcer during simulations based on the number of missing cells due to death from infection, and defined a lesion as any episode with a >1 mm ulcer (Schiffer et al., 2009).
The equations have been derived theoretically for calculating diameter of liquid drop produced by direct drop formation and ligament formation and the dimensionless equations obtained from the experimental results are applicable for calculating diameter of drops in a wide range of operating conditions.
Rather, it can be combined with digital programs that automatically calculate diameter, and an islet of any size, within a normal range, can be converted to cell number.
The experiments were measured under the condition of mass ratio of GAH NAG = 1 2 (total mass of 7.5 wt%) Fig. 8 Effects of different temperatures on a molecular polarities, b calculated molecular diameters of GAH and NAG.
This test was used to calculate the diameters of particles by hydrometer analysis.
