In the present paper, although power calculation was not discussed, the power would be calculated by setting the true second- and third-order moments and analyzing the moments using a null model.
The positive rate was calculated by setting a cutoff as average of normal the samples plus two standard deviation of this average.
For point-source analysis, or when you are not interested in the spatial variation of the effective area, unweighted ARFs can be calculated by setting weight=no.
One was calculated by setting β=3.0 and the other by setting β=3.5.
The peak signal-to-noise ratio (PSNR) of the stego images was calculated by setting the maximum pixel value to 255.
Such an effect is calculated by setting the final demands as follows: [ Δ D J Δ D N Δ D S ] ′ = [ − e e 0 ] ′. (9).
In the other, the front condition is calculated by setting a thin artificial bed ahead of the front (e.g., Toro 2001).
A corresponding perfusion center of gravity is calculated by setting the weights W i to the measured intensity at each position (x i, y i, z i ).
Indeed, the median of the boxplot is calculated by setting the flow rate and the diesel consumption to their median value (62.5 kg/s and 5,000 MJ/m, respectively).
The exchange rate of rhodamine from the bottom layer through the thermocline was calculated by setting the start value minus the equilibrium value as 100%, thereby normalizing the equilibrium rhodamine concentration to 0%, and then plotting the % values over time.
The BR term is calculated by setting c = 2/3 in Equation 3. Furthermore, we have calculated the electron charge density generated only by the second term, t / ρ term, as shown in Figure 5b.
