Sentence examples for calculated by multiplication from inspiring English sources
Values for FURL and FURR, corresponding to the left and right kidneys, were then calculated by multiplication of the total FUR by DRFL/100 and DRFR/100, respectively.
RPN is calculated by multiplication of O, S and D. Different combinations of O, S and D have different risk impacts but may produce same value of RPN.
The weight values that determine the best parts in each image were calculated by multiplication of a set of quality measures.
Absorbed doses to both kidneys and spleen were calculated by multiplication of time-integrated organ activity concentration with the appropriate ACDF, thus considering only the self-dose.
Panels (e)–(h) show the corresponding loading vectors (hat {sigma }_{1|q}hat {mathbf {v}}_{1| q},dots, hat {sigma }_{4| q}hat {mathbf {v}}_{4| q}) calculated by multiplication of the respective singular value (hat {sigma }_{i| q}) and right singular vector (hat {mathbf {v}}_{i| q}).
In spite of extensive use of FMEA for risk analysis, it has been criticized for number of reasons as discussed here: 1. RPN is calculated by multiplication of O, S and D. Different combinations of O, S and D have different risk impacts but may produce same value of RPN.
The amount of each species is calculated by matrix multiplication [18] to provide a quantitative analysis.
The nutrient content in the plant biomass was calculated by the multiplication between the contents and the dry matter of plants.
This is reasonable because, for the non-SI-SRINR method, the SR is calculated by using multiplication of SRINR which increases the complexity as discussed in Section 3.2.
The length of the top nanotubes is determined by the length that the interpore region is dissolved, and this transformed length is calculated by the multiplication of the interpore dissolution rate and the anodization time.
The corresponding block error rate (BLER) and throughput versus signal to noise ratio (SNR) curves of the look-up tables are illustrated in Figure 2. The instantaneous user data rate in each TTI is calculated by the multiplication of the number of bits per resource element obtained from the relative link adaptation table and the number of resource elements that a user has been assigned.
