Sentence examples for by using the steady from inspiring English sources
This paper presents results which were obtained for the flameless combustion of methane over the Pd(PdO)/Al2O3 catalyst by using the steady state isotopic transient kinetic analysis method.
The outer or the slow time-scale layer called a set-point optimizer is used to find the set points related to energy efficiency by using the steady state model; whereas, the inner or the fast time-scale layer is used to track the obtained set points.
The evolution of the temperature profile for Mars was calculated from surface heat flow and heat production by using the steady heat conduction equation (Turcotte and Schubert 2002).
By using the steady state conditions for BX in the equation for X, we see that the steady state profile of X is governed by the equation: (A33) Now in this equation, we note that the profiles of AX and A are uniform.
Aggregation numbers were measured by using the steady-state fluorescence quenching method, whereas surface potentials were computed by solving the non-linearized Poission Boltzmann equation.
We establish some important performance measures for the F-policy and N-policy models by using the steady-state probabilities obtained for different system states.
Therefore, π can be obtained as the normalized single eigenvector associated with the unit eigenvalue of P. In this section, we derive throughput, delay, capture probability, energy, and energy efficiency for FF-NDMA by using the steady-state probabilities obtained in Section 3.2.
Therefore, making use of the strong law of large numbers and the stability assumption, we can measure the degree of mobility in the long-run by using the steady-state value of the intergenerational correlation IC of asset holdings between two successive generations as in Bossmann et al.
Equations 1 and 2 were derived from Scheme 1, for the ping-pong and ping-pong-pong pathways, respectively, by using the steady-state approximation.
During the past four months, this index has swelled by 35%, using the steady support of its 10- and 20-day moving averages.
However, the influence of thermal mass and insulation material distribution cannot be analyzed well by using the current steady state thermal resistance (i.e. R value) and thermal inertia index (i.e. D value).
