Sentence examples similar to by using general element from inspiring English sources

All the beams were analysed by the finite element method by using general finite element analysis software ANSYS and the results were compared with those obtained experimentally.

The test results were compared with design results in accordance with American Aluminum Design Manual, GB 50429-2007 and Eurocode 9. A finite element (FE) model of the tested specimens under axial compression has been developed by using general finite element software ANSYS, and was verified by using the test results reported herein and other experimental results presented in the literature.

A risk element was considered in a dynamic PERT network by Li and Wang (2009) who, by using general project risk element transmission theory, proposed a multi-objective risk-time cost trisk-time costem.

Most finite element models of actual projects developed using general finite element software are rigid or hinge connected.

All the numerical results presented in this study were evaluated using general purpose finite element commercial software ANSYS together with the post-processing program (using FORTRAN) developed by the authors.

By using the general finite element (FE) software package ABAQUS, elaborated FE models were developed and validated against the obtained test results and other available existing test data.

By using a general beam element that contains a discontinuous cross-section, piping analysis is performed to obtain the reduced load.

With this objective a parametric study was carried out, based on modeling of 140 RCC under monotonic loading by using the general finite element package ABAQUS.

Numerical verification is performed by using the general purpose finite element package ABAQUS.

In this paper, the behaviour of circular concrete-filled lean duplex stainless steel carbon steel tubular (CFSCT) short columns under axial loading is investigated by using the general purpose finite element analysis program ABAQUS.

The effectiveness of the proposed method is validated through several examples covering a wide range of T,L, and S values; the calculations are performed by using the general purpose finite element software ABAQUS.