Sentence examples for by using flow rate from inspiring English sources

It was designed by using flow rate ratio, i.e. the flow rate ratio determines which streamlines flow into the trapping structure.

Sequential elution of peptides was accomplished by using a flow rate of 250 nl/min and a linear gradient from Solution A (2% acetonitrile; 0.1% formic acid) to 50% of Solution B (98% acetonitrile; 0.1% formic acid) in 40 minutes over the pre-column in-line with a homemade 15 cm resolving column (75 μm I.D.; 375 μm O.D.; Zorbax 300-SB C18, Agilent Technologies).

As H2O2 production was directly proportional to current density, the treatment system could be scaled up by using faster flow rates accompanied by higher applied current densities or by increasing surface area of the cathode.

Reduction of contrast volume can be achieved by using lower flow rates such as 3 ml/s or less [31].

By using lower flow rates, and longer residence times for the sample in the column, the conditions were adjusted so that some of the drug protein complex could dissociate during passage through the column, thus increasing the apparent free drug fraction and making it possible to determine the dissociation rate constant for the drug with the soluble protein.

In sheep experiments, Young et al.[ 17] achieved 130 to 180 ml CO2 elimination (500 ml/L pCO2 in blood at 40 mm Hg (5.3 kPa) calculated) by using blood-flow rates of about 500 ml/min, combining a hollow-fiber gas exchanger and a hemofiltration device.

The stained cells were analyzed by flow cytometry directly (FC500, Beckman Coulter, USA) and the apoptosis rate was quantified using Flow Jo software.

Samples were separated by nano liquid chromatography using a flow rate of 300 nl/min.

Peptides were diluted in 0.1 % formic acid and analysed by direct infusion mass spectrometry using a flow rate of 200 nL/min.

Conductance tests suggest that the solution around a patch under study was controlled by the application of a solution using a flow rate of 100 μl/min or greater.

The ignition delay time was proportional to the gas-phase mixing time, which is estimated by using the inverse flow rate.