Subsequently, US scanning by using a low-MI (≤ 0.1) technique, CnTI (Contrast tuned Imaging; Esaote, Genoa, Italy), was performed to ensure sufficient enhancement after bolus administration, allowing an examination window of up to 5 minutes.
More recently, cold-setting polymer dispersions in water have been introduced by using a low-pressure suction table, from which the water is removed through spaced perforations in the table surface with a powerful downdraft of air.
The most efficient performance that is, the greatest output of work in relation to the heat supplied is secured by using a low condenser temperature and a high boiler pressure.
These objectives are achieved by using a low periapsis orbit.
Si/alloy was prepared by using a low-cost and low-temperature mechanical ball milling process.
Main device characteristics have been measured at T=4.2 K by using a low noise readout electronics.
The requirement of a high sensitivity and low noise could be obtained by using a low-resistive channel.
To validate our theoretical analysis, numerical investigation is conducted by using a low order model.
Hidden anchors were generated by using a low pass filter with a cutoff frequency of 3.5 kHz.
By using a low duty factor gait such as the trot gait, the walking velocity can be increased.
