Sentence examples for by the rolling process from inspiring English sources

The four-bubble failure criterion does not indicate whether a fatigue crack initiated on the fillet surface can propagate through or arrest in the compressive residual stress zone induced by the rolling process.

By comparing two types of HTS tapes drawn by ED dies and a set of reference round dies, we found that the ED process can improve the qualities of the rolled tapes, such as improving the homogeneity of both the center and the peripheral filaments of the tapes, reducing the micro-cracks caused by the rolling process.

You can speed up the rolling process by using the heel of your palm to flatten each piece of dough into a roughly circular shape before you roll it out more thoroughly.

Repeat the rolling process with each piece of dough.

In this paper, the influence of the residual stresses induced by the fillet rolling process on the fatigue process of a ductile cast iron crankshaft section under bending is investigated.

The plastic zone development and the residual stress distribution near the crankshaft fillet induced by the fillet rolling process are then investigated by a two-dimensional elastic plastic finite element analysis.

A nonlinear finite element analysis is implemented to approximate the stress distributions induced by the crankshaft rolling process, and a crack modeling technique is developed to calculate the equivalent stress intensity factor ranges based on the combined residual and operational stress distributions along various crack growth planes.

The purpose of this paper is to analyze the bar rolling process by means of the three-roll planetary mill with a three-dimensional elastic plastic finite element model.

The results of mechanical tests and DSC analysis show the increasing of polypropylene molecular alignment by rolling process is the most dominant reason of improvement the mechanical properties of sandwich composites.

The paper will be concluded by simulation results of the ring rolling process and comparisons with experimental results.

The residual stress distribution near the crankshaft fillet induced by a fillet rolling process was then determined by a three-dimensional elastic plastic finite element analysis.