Sentence examples for by the reference sensor from inspiring English sources

It is noted that the DDOA measurements determined for different sensors are correlated, because they exploit the same TOA measurement set generated by the reference sensor.

It is noted that the DDOA measurements generated by different sensors are correlated, because they utilise the same TOA measurement generated by the reference sensor.

Hence, days of observation were grouped into three categories (dry, overcast and wet) according to the minimal daily RHrefmin as measured by the reference sensor.

The light extinction coefficient k was calculated following the Lambert Beer extinction law I = I0 × e− k LAI by using the determined LAI of the leaves and light intensity at the ground level (Saeki 1959; Spehn et al. 2000), where I = PPFD at the ground level and I0 = PPFD above the canopy measured by the reference sensor.

The convergence performance of the ANC algorithm is analyzed in detail, and the result shows that the reference paths and the secondary paths determined by the position of the reference sensors, loudspeakers and error sensors are the main factors to the final performance.

The technique is based on using inter-relationships established using model simulations of the radiation measured at the top of the atmosphere by the reference and candidate sensors to transfer the calibration of the former to the latter, using a radiometrically stable desert calibration site as a calibration transfer platform.

In order to determine a unique set of DDOAs, in which no measurement is a linear combination of any of the other measurements, the DDOAs are calculated between a reference sensor (denoted throughout by the index "R") and each of the other sensors.

Moreover, a comparison between the data obtained by this device and a reference sensor is included.

The dynamic responses obtained with these sensors were compared with the response of a reference sensor without a zeolitic layer.

A Hybrid Active Noise Control (HANC) system is used to attenuate disturbances in a scenario where a portion of noise is captured by reference sensors.

Calibration was performed by calculating the mean and standard deviation of the range of readings from the VIEW and HORIBA/SUPARCO sensors as follows: ● μ1 = Mean of Reference sensor readings.