Sentence examples for by the optimum process from inspiring English sources
The photographs of bulk Si and antireflective Si fabricated by the optimum process conditions are displayed in Figure 7b.
Utilizing this methodology enables identification of the desired properties by targeting the optimum process performance without committing to any components.
The film showed one (37 GPa) of the highest hardness values for a DLC film produced by CVD at the optimum process condition.
c Histograms of PCE of the perovskite solar cells prepared by high-concentration MAI under the optimum process condition for 50 devices.
A quadratic model was proposed to correlate the independent variables for maximum ash reduction at the optimum process condition by using central composite design (CCD) method.
After validation of the experiment using the optimum process parameters generated by the Design Expert software, the l-DOPA production was observed in the medium before optimization and after optimization.
Based on that, the optimum process conditions determined by RSM were as follows: pH value 4.5; broccoli wall material ratio 50% and concentration of wall material 4%, where the theoretical and practical encapsulation efficiency was 60%and58%8%, respectively.
In the next section, we investigate the possible common optimum combinations of TROP and GRAD values across the entire GEONET network, based on the frequency distributions of the optimum process noise combinations deduced by comparing data from different days.
The optimum process conditions were determined by analyzing the response surface of a three-dimensional plot and by solving the regression model equation.
The optimum process conditions were determined by analyzing response surface three-dimensional surface plot and contour plot and by solving the regression model equation with Design Expert software.
The optimum process parameters were found by the effect factors of the CRT which was bounded by the two important process parameters, i.e. the ion implantation dose and the processing time, for the engineering practice due to the available dependence on the surface modification effect in suitable costs.
