Sentence examples for by the maximum deviation from inspiring English sources

The limits of the use of computer-guided piezocision are set by the maximum deviation observed; thus a safety distance of 1.5 mm should be considered, which confirms that this innovative technique is clinically applicable.

The score for a candidate gene is defined by the maximum deviation between its weighted neighboring expression and the randomized expression.

Using the log likelihood ratio values obtained for its member genes, it computes enrichment score of a pathway in a sample by the maximum deviation of the random walk from zero, as in GSEA.

To this end, an Optimal Tap Control OTCC) method is proposed to regulate On-Load Tap Changers (OLTCs) by minimizing the maximum deviation of the voltage profile from 1 p.u. on the entire feeder.

Given that weight could be measured accurately and only tablet halves used as recommended by WHO (1), the maximum deviation in dose could never be more than 300 mg per individual.

The choice of thermal conductivity model has a noticeable impact on the plate-fin multi-stream heat exchanger design, and the maximum deviation by using different thermal conductivity models is 7.5%.

We denote the latter two local maxima by (lambda_{0} (X ) ) and (lambda_{n+1} (X ) ). (c) The greatest and the smallest local maxima of (L_{n} (X;x ) ) are denoted correspondingly by ({{mathcal {M}}}_{n} (X )) and (m_{n} (X ) ); we denote by (delta _{n} (X ) ) the maximum deviation among the local maxima (delta_{n} (X )={mathcal {M}}_{n} (X )-m_{n} (X ) ).

The significance was indicated by the P value for the maximum deviation between two cumulative distributions.

The significance for KS test was indicated by the P value for the maximum deviation between two cumulative distributions of C d and C n (Formulas 2).

Compared with the PMV, the maximum deviation can be decreased by 79.5% with the CPMV method in evaluating the thermal comfort of solar conditions.

The maximum deviation between the predictions by the model and the measurements is 2% for the mass flow rate, 5% for the shaft power and 3 K for the discharge temperature.