Sentence examples similar to by the half height from inspiring English sources

Half-height width for each individual site was calculated as follows: the half height was calculated by dividing the maximum ChIP signal within ±1000 bp of each 19 bp CTCF motif by the background signal, which was defined as the median ChIP signal between −1000 to −900 and +900 to +1000 bp relative to the motif.

Openings and closures were identified by the half-height criterion.

Figure 3B shows that smaller fragments provide the highest resolution as measured by the half-height width of the peak at each CTCF site.

This distribution is characterized by the position of the maximum near 2.4 nm and a broad width of the peak at the half-height (about 2 nm).

The half-height width for each motif was calculated by counting the number of contiguous base pairs that had ChIP signal greater than or equal to the half-height.

A high and low value for Δex is determined by direct half height width comparisons to these references.

This paper presents an experimental investigation of the effectiveness of strengthening half height full size concrete columns by placing concrete jackets.

The commonly accepted metric for quantifying the efficiency of the ion mobility separation is resolving power, which is based on a single peak definition of the peak centroid divided by the width of the peak at half height.

" w0.5 " is the peak width at a half height.

Assuming uniaxial symmetry, a measure of the extent of fibril disorientation with respect to the stem axis was found by calculation of the full width at half height (FWHH) of the 200 and 004 azimuthal profiles, after fitting to single or superimposed Gaussian function(s).

The flow rate is calculated according to the formula: τ dyne / c m 2 = 3 * μ * Q / 2 * a 2 * b [ 18] with μ (dynamic viscosity) = 0.083 dyne*sec/cm (DMEM, 5% calf serum at 37°C [ 19]); Q (flow) = variable value to be controlled by the pump in cm/sec; a. (half height of chamber) = 0.125 mm; b. (width of chamber) = 2 mm.