Sentence examples for by the former method from inspiring English sources
The results obtained by the former method are more reproducible.
A comparison between the ANN and PLS methods revealed the superiority of the results obtained by the former method.
The analysis proves that this method can produce many sequence sets that do not appear in sequence sets generated by the former method, especially shorter sequence sets.
The electroactive fraction of Nafion[Ru bpy 32+] prepared by the former method was lower than that prepared by the latter.
In the case of the alloys prepared by the former method, the addition of more than 4 at.% Al resulted in a two-phase microstructure consisting of disordered fcc Ni solid solution dispersions in the L12 matrix, while in the case of the alloys prepared by the latter method, the addition of 4 at.% Al retained the L12 single-phase microstructure.
In the case of the 4 at.% Al-added alloys, the room-temperature tensile properties were similar and independent of the alloying methods, whereas the high-temperature yield stress was higher in the alloys prepared by the latter method than in the case of the alloys prepared by the former method.
It has been shown, however, that the detection of rabies maAb by immunoblotting is much more sensitive than the RFFIT, and consequently, by using the former method, maAb could be detected for a longer period of time (Müller, unpublished results).
The SLAC and FEL methods estimate selection on a site-by-site basis with the former method comparing observed to expected synonymous and non-synonymous rates while the latter uses two models which assume independent and equal rates and a likelihood ratio test to determine significance.
The 105 EMs with weighting factors bigger than 0,1 selected by the Schwartz and Kanehisa [ 29] method contain the 20 EMs selected by PLP but the former method does not link the EMs with the envirome.
From Figs. 13 and 14, it can be found that, the performance of active damping method by building ( R_{v} ) is better than the active damping method by building ( C_{v} ), because the former method can achieve almost the same damping effect with relatively smaller undesirable oscillation in rotating speed.
This may be done by subcutaneous incision or by an open wound; probably the former method will suffice in the majority of cases, and is to be preferred on account of the smaller or insignificant character of the wound.
