Sentence examples for by taking the spatial from inspiring English sources

Spatial DA was done in the same way as temporal DA, by taking the spatial clusters obtained in cluster analysis as the grouping variable and the 14 measured water quality parameters as the independent variables.

We use the data envelopment analysis (DEA) method to estimate the relative efficiency of the current strategy for each player in a game by taking the spatial distribution of strategies as input and the total payoff as output.

Using the optimized structures of the model compounds, the probable combinations to form a flat ring polyimide are considered by taking the spatial angles between the respective aromatic groups into consideration.

Gridness scores were calculated following previous studies (Sargolini et al., 2006), by taking the spatial autocorrelation of each firing field (a region corresponding to a circle with radius λgrid/2 and a centre in the middle of the autocorrelation function has been removed) and rotating in steps of three degrees.

Subsequently, the avr Rvi6 subpopulation was analysed by another clustering method (TESS), taking the spatial distribution of samples within the orchard into account.

However, the calculation can be simplified by taking the Fourier transform of spatial distributions of the field into consideration.

Simulation results show that the improved transmission rate and signal power capacity can lower the probability of data intercept (LPI) and detection (LPD) by taking the advantages of both temporal and spatial diversities.

Through this way, the improvement of transmission rate and signal power capacity are able to lower the probability of data intercept and data detection (LPI and LPD) by taking the advantages of both temporal and spatial diversities.

Although the individual differences in the opacities between Nemuro and Sapporo were up to ~100%% due likely to spatial variability of H2O, the monthly mean differences in the opacities were less than 15%% (i.e., smaller than bias in the measured opacity) since the spatial variability was decreased by taking the monthly mean.

The B-scan GPR image in spatial domain is obtained by taking the Inverse FFT of the back scattered signal data in the frequency domain as shown in Fig. 7a and b.

Then, the resulting distortion in the spatial domain D ^ s is evaluated by taking the inverse transform.