Sentence examples for by setting the frequency from inspiring English sources

Buckling problems can be solved by setting the frequency parameter to zero.

The flutter loads follow by setting the frequency derivative of the determinant of this matrix equal to zero; the energetic interpretation of this latter is also given.

It is shown that the disturbance imposed on the decision variables can be made significantly small by appropriate adjustments to the observer bandwidth, and that most of the sensor faults and actuator faults can be detected and some of them can be isolated in the frequency domain by setting the frequency characteristics of the post-filters appropriately.

In the fourth simulation experiment, the effect of allelic frequency on QTL mapping was assessed by setting the frequency ratio of the two alleles as 1∶1 (uniform distribution), 1∶2 (skewed distribution) or 1∶3 (skewed distribution).

After narrowing down the most frequently used PROMS by setting the frequency arbitrarily at five, the resulting instruments were further analysed by the individual items within each instrument.

Therefore, the peak voltage gain due to crosstalk can be significantly reduced by properly setting the frequency.

The circuit is also protected by setting the inverter frequency and dead time of a digital PWM chip.

A step is detected when A norm reaches a local maximum higher than a given threshold A 0. By setting the sampling frequency as f s and number of samples between two adjacent maximum as Δ N, the time duration of the kth step is ({t_{k}} = frac {Delta N}{f_{s}}) and the corresponding estimated speed is {v_{k}} = frac{P_{k}}{t_{k}} = frac{{P_{k}}{f_{s}}}{Delta N} (9).

They established a rule to optimize the decision process, using the p-value introduced by Fisher, by setting the maximum frequency of errors that would be admissible.

Web sites can control the frequency of preflight requests by setting the header Xdc-Max-Age, and the frequency of DNS lookups by setting the header Xdc-Options (Section 4.2).

The effects of frequency bandwidth and the number of modes in a band were separated by using frequency averages at a series of constant bandwidths rather than one-third octave averages, while the modal overlap is made independent of frequency by setting the damping loss factor to be inversely proportional to frequency.