Sentence examples for by replacing the values from inspiring English sources
Finally, by replacing the values from Table 2, as in the example above, and rearranging terms, expression (36) is reached.
Finally, by replacing the values of C and (C^{T}) found as such, we get the constraint (29) given in the second part of the corollary.
By replacing the values of VCC, Vt, L, and M in (18) and (19), it can be found out that the power consumption on the chip on which the circuit is implemented is reduced by a factor of (1/9).
The other four RPEs in Eq. (39) are solved by replacing the values of (V_{x_{e}}, V_{y_{e}}, V_{x_{p}},V_{y_{p}}) that are in Eq. (45) and using the initial conditions (in retro time) from Eq. (40).
The matrix was transformed into a binary matrix by replacing the values of all correlations > 0.7 by 1, and assigning the others as 0. The resulting binary matrix induced the adjacency matrix of the coexpression network, in which genes form the nodes and two genes are connected by an edge if they are correlated above 0.7.
To this end, frequencies that exceeded 0.05 Hz were removed using a low pass filter and clear technical artefacts (e.g., due to an optode losing contact to the scalp during measurement) were corrected by means of interpolation by replacing the values of the corresponding channels with the values of the circumjacent channels in a Gaussian manner (closer channels were taken more into account).
The existence results (Theorems 3.1, 3.3, 3.5, 3.6) for problem (4.1) can be obtained using the strategy followed in Section 3 by replacing the value of ω with the following one: omega_{1}= frac{1}{Gamma(alpha+1)}+frac{1}{|Theta|} biggl{ frac {|A|}{Gamma(gamma+alpha+1)}+ frac{|B|(logeta)^{alpha}}{Gamma (alpha+1)} biggr}.
In these cases, missing scores were handled according to recommendations in the BRIEF-A manual, by replacing the missing value with the value 1 (never).
By replacing the admissible values of φ into system (24), the corresponding values of ψ are obtained.
For on-body packet forwarding, the PLC is used exactly the same way as for the UTILITY routing, that is, by replacing the utility values by the PLCs.
By replacing the above values into the conditions of Theorem 3.2 and by taking into consideration that c > 0, we get 0 < c < 0.5.
