Sentence examples for by optimizing the concentration from inspiring English sources
In our study, we primarily assessed a rational approach for designing and formulating ideal long-circulating nanoparticles by optimizing the concentration of chitosan (CS) and polyethylene glycol (PEG).
Meanwhile, we improved the technology by optimizing the concentration of Cas9 and sgRNAs and designing two adjacent sgRNAs targeting one exon for each gene, which greatly increased the targeting efficiency and bi-allelic mutations.
The efficiency of Dye-Sensitized Solar Cells (DSSC) can be significantly enhanced by optimizing the concentration of surface trap states and by tailoring the band gap energy in the semiconductor oxides used as photoanodes.
The silica nanospheres in Fig. 6 were not well dispersed, by optimizing the concentration of the nanospheres by diluting it to a ratio of 1 15, better dispersion of silica nanospheres on glass substrate was achieved as shown in Fig. 7a, and this distribution is highly repeatable.
Further increases in yield might be achieved by optimizing the concentration and dosing method of the inducer and the timing of induction.
The coercivity (Hc) was found to decrease to 6 Oe while the saturated magnetic flux density was maintained higher than 1.8 T by optimizing the concentrations of tartaric acid and citric acid in the electroless plating solution.
Despite the increased sensitivity gained by optimizing the concentrations of all 3 antibodies, the improved signal was still quite low when compared to previously reported values [ 23].
This is less still than the 2-3 log10 units reduction (Amoah et al. 2007b) which are possible by further optimizing the concentration and exposure time.
Consequently, by optimizing the TPA concentration, we obtained highly efficient and stable low-temperature processed electron transport material (HTM -free carbon based perovskite solar cells (PSCs).
In this work, we achieved a good (ZT eng by optimizing the carrier concentration to improve the room temperature ZT using deep lying dopant, indium, in PbTe1−ySy.
By optimizing the doping concentration, the maximum power conversion efficiency can be achieved to be 0.90% with a 10 mCi/cm2 Ni-63 source radiation.
