Sentence examples for by multiplying the output from inspiring English sources

SNR is adjusted by multiplying the output noise by the following factor: (10).

LBP code assigned to the central pixel is calculated by multiplying the output of the threshold function by the term 2 p  for each neighbour pixel and then summing all those values.

Using these fitting parameters, we calculated the mean organ absorbed dose per unit administered activity for each part of the paired organ by multiplying the output of Eq. (2) by the corresponding residence time.

To enable comparison of all hybridization data, global scaling was applied by multiplying the output of each experiment by a Scaling factor (SF) to make its average intensity equal to a user-defined Target Intensity (which was set at 1500 for these experiments).

The l th channel coefficient is estimated by multiplying the despreading output by the transmitted pilot sequence.

Finally, a global controller is designed by multiplying the controllers' output with the corresponding weighting coefficients.

The annual energy can be calculated by multiplying the power output of the wind turbine P v) for each wind speed for the total number of hours when the velocity v occurs.

In cases where spectral variation exceeded the dynamic range of the spectroradiometer and thus a reliable measurement could not be obtained, the irradiance delivered under the background condition was calculated by multiplying the measured output of each light source by the spectral transmission of the filters used in producing the background condition.

Without dividing the age by two and then multiplying the output by two, the trend-lines based on the parameters (a, b, c) would be too low, and would not perfectly match the mortality data points.

With a quarter-block representation, a grid system of 11 × 11 × 1 can reproduce the same results of a single block after multiplying the output by 4. Tables 1 and 2 in "Appendix 1" show the data used as parameters for the simulation study.

In addition, the contents of register Particle S are used in the output calculation by multiplying the particle x and y values by 1/M and accumulated to get the mean output values (the X and Y positions of the tracked object).