Sentence examples for by minimizing the deviation from inspiring English sources

New model parameters are estimated by minimizing the deviation between the synthetic data and the model.

This objective is accomplished by minimizing the deviation between the designed surface and the actual surface during machining.

Because the real sound source location leads to zero deviation, the sound source can be finally located by minimizing the deviation matrix.

Multi-dimensional scaling (MDS), for example, calculates coordinates for a 2-dimensional embedding of the experimental data by minimizing the deviation between embedded and original data (Kruskal stress).

In contrast, if model fitting were to be done using the original oscillating waveform and associated methods (for example by minimizing the deviation between experimental and model signals), invalidation of the single-gene model may not be as clear because the imperfect overlap between the fitted model and data may be blamed on noise.

A tactical plan is obtained by minimizing the deviations of the resources consumption to the target levels of resources utilization, following a goal programming approach.

Afterwards, to determine decision makers' (DMs') weights objectively, an optimization model is established by minimizing the deviations between each individual IV-AIFPR and the collective one.

We use the Excel "Solver" to estimate the parameters that define the mass transfer coefficient by minimizing the deviations in water content between calculation and a calibration drying experiment.

Updating a construction schedule can be defined as an optimization problem to find a new schedule considering new information by minimizing the deviations from existing project goals.

In our simulations, parameters τ R = 0.22 months, D = 2.5 and τ f = 5.6 months were chosen by minimizing the deviations of computed EDD and wall thickness from measurements at senescent age, i.e. (R i - R i, exp 2 + (WT - WT exp), in which WT means wall thickness.

The optimal torus parameters were estimated by minimizing the standard deviation of distances from the surface mesh to the centerline of the torus.