Sentence examples for by introducing the additional from inspiring English sources

This is achieved by introducing the additional states corresponding to the relative distance between leading and following vehicles, and also the velocity of the leading vehicle.

Moreover, the coupling effects of composite laminates, especially asymmetric laminates are considered by introducing the additional coupling terms among translations and rotations into the multiscale base functions.

It was demonstrated that the buckling resistance can be significantly enhanced by either increasing the stiffness of a few hoop ribs located in the close proximity to the section with the larger diameter, or by introducing the additional hoop ribs in the same part of the conical shell.

Although the PET substrate is flexible and can provide mechanical support to the graphene film, it does not provide any capacitance as supercapacitors, thus the device capacity would be affected by introducing the additional PET substrate.

Angle α is obtained by introducing the additional variables displayed in Fig. 1a as follows: {displaystyle begin{array}{l}x=frac{t tan theta }{2} alpha ={cos}^{-1}frac{t tan theta }{2r}end{array}} (5 where t is the thickness of the nanohole.

PB1+ was produced by introducing the additional mutation E80Q to PB1.

We proceeded by introducing the two additional predicted AHNAK peptides into our fusion protein and found that they were also cleaved upon co-expression with CAPN3 (Figure 1E), consistent with previous data that CAPN3 cleaves AHNAK at multiple sites.

The Shields number was revised by introducing the cohesive force and additional static water pressure, which indicates that this study could be seen as an extension of the Shields curve method for silt.

In additional, by introducing the guiding from geometric similarity and labeling structure, and the robust ℓ2,1 norm, our method generates correct labeling, even when the set of given examples contains multiple object categories or mislabeled meshes.

Additional advantages by introducing the feed&bleed principle in the concept are demonstrated too.

It is shown that the whole temperature influence can be modeled by introducing the special power function with one additional parameter, which is put under the integral.