Sentence examples for by illuminating the sample from inspiring English sources

The photoresponse of the device was measured by illuminating the sample with a halogen MR16 lamp with a light intensity of 110 mW/cm2.

Spectral photoluminescence (PL) measurements were performed by illuminating the sample with the λ = 647 nm of a krypton ion laser and collecting the resulting PL signal with a N2-cooled GaInAs photomultiplier.

MicrOmega will observe samples with a field of view of a few millimeters with a spatial sampling of 25 μm and acquire near-infrared spectra by illuminating the sample sequentially with different wavelengths from 0.99 to 3.55 μm over two spectral channels with a typical spectral sampling of 20 cm−1.

The circular dichroism of the sample was measured as the g-factor (g), which is defined by the equation,( g=left {E}_{mathrm{RCP}}-{E}_{mathrm{LCP}}rig=left {E}_{mathrm{RCP}}-{E}_{mathrm{LCE}_{mathrm{LCP}}right)}{2}right) ) where the extinctance E RCP (E LCP) was measured by illuminating the sample with right-handed (left-handed) circular polarized light.

Photoconversion of mKO was performed by illuminating the sample for 10s with light from a 100 W Hg lamp filtered by a 436/20 nm filter.

This is achieved by illuminating the sample with three different wavelengths each projecting a sinusoidal pattern with the required phase.

We photoswitched mKikGR (500 µl, 5×10−6 M) by illuminating the samples with a diode-pumped solid-state laser at 405 nm (CrystaLaser) at a power of 1.2 12 mW cm−2.

The reaction was initiated by illuminating the samples under a 15 W fluorescent tube.

Oblique illumination often produces asymmetric shading effects which we avoid by symmetrically illuminating the sample.

We note that the last four enhanced-resolution components { G k | k = 5, 6, 7, 8 } in Eq. (6) contain cross-correlation terms involving orthogonal frequency shifts of H c. These terms require the orthogonal shifts to be simultaneously aliased into the system's detection passband, and imply that Y S I cannot be reconstructed by simply illuminating the sample with a rotating sinusoidal pattern.

Monomeric c-E-helix-PYP was produced by illuminating the dimer sample with blue light.