The limited success of across breed imputation from 50 k to HD is most likely caused by differences in LD phase and thus haplotype dissimilarity across breeds on the 50 k panel [ 8, 11], but the greater marker density on the HD panel might alleviate these differences for diverged breeds [ 12], meaning that across breed imputation could be successful from HD to whole genome sequence data [ 11].
The difference between the disruptive behavior of single droplets and droplet pairs is explained by differences in liquid-phase circulation induced by the gas-phase asymmetry of the droplet pair.
In particular, a new high throughput compatible approach for the characterization of aqueous two phase systems regarding tie lines by exploiting differences in phase densities is presented.
The differences in the induction values found for these genes between cells spread plated on semisolid MM (Fig. 5B) and cells from the border of a typical swarming colony could be explained by differences in the growth phase of the two samples.
The ssq impedance is shifted upward (because of the site gain at this station) and contains a frequency dependence, as demonstrated by differences in the magnitude and phase derived from the distorted and undistorted ssq impedances (Fig. 10b).
Variances in antigenic exoproteins between MW2 and LAC are likely explained in part by differences in gene content or phase of growth used to test antigenicity (Fig. 4).
Chromatography is a separation technique in which compounds are separated by differences in their distribution between two phases, one of which is stationary (the stationary phase), while the other, a gas, liquid or supercritical fluid, is mobile (the mobile phase) and is responsible for transport of the compounds over or through the stationary phase.
As the acute-phase reactant CRP was not elevated in our cohort, the increased MIF levels in patients with pSS cannot be explained by differences in the extent of acute-phase response.
A bi-static acquisition removes temporal de-correlation, i.e. phase noise caused by differences in the position of branches and in moisture.
The discrepancy between response phases may be caused by differences in the model and the experimental design.
