This approach has the main advantages of a reliable preservation of the polarization state of the light inside the FDML laser and a simplification of the fiber-based connection between the FDML laser and the buffer stage, by avoiding the needs of inserting additional polarization control elements, e.g. polarization paddles, between the two devices.
The signaling overhead is reduced by merely considering MTC QoS class identifiers (QCIs) which are known in the beginning of a connection and by avoiding feedback messages regarding the buffer status and channel conditions.
Absorbance was measured at 312 nm to avoid absorbance by the buffer and all solutions were excited at this wavelength for emission spectra.
Moreover, care was taken to limit Fischer esterification conditions during sample preparation by maintaining the pH of digestion buffers >8, by avoiding exposure of samples to high concentrations of methanol in the presence of acetic acid, and by avoiding methanol as a co-solvent during LC separation of the peptides.
In total, we simulated a region of 1,050 kb, including a 50 kb gene and 500 kb up- and down-stream to allow for an imputation buffer to improve accuracy by avoiding edge effects and taking advantage of the expected long-range linkage disequilibrium (LD) with rare variants [ The International HapMap Consortium, 2007.
The presence of ash, present at higher levels by adding WS to the mixtures, could 'buffer' extreme acidic conditions, avoiding the generation of sugar degradation products including furans.
Further improvements in precision have been obtained by avoiding a complete standstill of liquid within the capillary and flushing the capillary with buffer for 25 min after each 30 consecutive runs.
Prevent the disease by avoiding mosquito bites.
By avoiding a comparison between data from normal and heavy water buffer solutions, no correction is needed for the significant differences in protein stability that can result (51).
To avoid the effects of blood buffer capacity, the concentration of working buffer in the measurement cell should therefore be not less than 5 mM.
