Sentence examples for by applying the analysis from inspiring English sources

By applying the analysis of the signal-to-noise ratio (S/N ratio) & analysis of variance (ANOVA) the optimum combination of process parameters & the importance of the levels have been ascertained in some respects.

By applying the analysis of variance, it was also found that the greatest impact on wear rate has interaction of load and % volume of hBN with percentage effect of 51.89%, then % volume of hBN with 35.04% and load with 13.06%.

From these tests were retrieved sixteen surface roughness measurements The influence of each parameter in surface roughness were then obtained by applying the analysis of variance (ANOVA) to experimental data.

By applying the analysis to a series of capped perpendicular media, we found that a thick capping layer with a low saturation magnetization effectively reduced SFD without rapidly increasing the magnetic correlation length.

By applying the analysis of SEM, XRD, Confocal Laser Scanning Microscope (CLSM), apparent contact angle (CA) measurement and water droplet dynamic behavior analysis, the effects of both mesh size and nano-sized structures on the hydrophobicity were discussed.

Nine mixtures are designed by the Taguchi method considering the factors of sodium carbonate content (SCC), water to solid ratio (WSR), waterglass modulus (WGM) and waterglass content (WGC), and the experimental results are evaluated by applying the analysis of variance (ANOVA) method.

First, power of dispersion indices are obtained by applying the I O analysis method.

Finally, by applying the sensitivity analysis results, a new optimized design of the motor resulted in better performances.

Then, by applying the spectral analysis and the principle of exchange stability, we prove that the bifurcation solutions near the bifurcation points are locally asymptotically stable.

By applying the Tauc analysis (in its generalised form: (αhν) γ versus hν) on region I and take γ = 1/2, the resultant graph is shown in Figure 4b.

By applying the stochastic analysis, uniform design and RSM, the mean and the standard deviation (SD) of product quality are calculated as functions of the controllable process parameters.