Fig. 4 Occlusal adjustment was simulated by altering the load-displacement curves of the springs Fig. 5 Schematic diagram for each phase of the load-displacement curve after occlusal adjustment of implants.
By altering the container loading efficiency it was possible to develop an understanding of influencing factors on forces subjected to a loaded container.
Fig. 7 Initializing models altering the load displacement curves of springs.
Occlusal adjustment was simulated by means of altering the load-displacement curves of the springs on the implants.
We achieved controlled release rates of multiple antiretrovirals ranging from μg/d to mg/d by altering the orifice design, drug loading, and mass of pellets loaded in the device.
Although obesity has been thought to contribute to LBP primarily by altering the distribution of mechanical loads on the spine, the additional contribution of obesity-related conditions such as diabetes mellitus (DM) to LBP has not been thoroughly examined.
Release profiles were successfully manipulated by altering the phase of growth factor loading and microparticle crosslinking extent.
More interestingly, release studies, in conditions that model the expected collagenase concentration of injured cartilage, demonstrated that by altering the microparticle crosslinking extent and loading within OPF hydrogels, TGF-β1 release, composite swelling, and polymer loss could be systematically altered.
The statistical software SAS JMP, version 8 was used for the 3 × 3 central composite design in which 16 pretreatment combinations were derived by altering the three independent variables: alkaline loading, temperature, and time (Table 1) and to analyze the experimental data obtained.
Situation I is operation mode adjustment, where the network topology is optimized by altering the states of switches according to the loads, thus achieving particular aims such as active power loss minimization.
