Sentence examples for by adjusting the oxygen from inspiring English sources
By adjusting the oxygen content, the flor yeast may be induced to develop and produce acetaldehyde in a submerged culture, a process used commercially in California.
By adjusting the oxygen partial pressure from 0%to3%3%, a series of samples were prepared.
However, forming free RRAM devices have been reported [85] by adjusting the oxygen stoichiometry of the active layer.
Each deposition was made with a fixed cathode voltage and the cathode current was controlled by adjusting the oxygen flow in a feedback loop by means of which a constant power was maintained.
The performance the BFIM process can be improved by adjusting the oxygen enrichment, blast temperature, blast dosage, pressure ratio of the Brayton cycle's air compressor and relative pressure drop of the air compressor inlet to their optimal values, respectively, which are new findings of this paper.
Consequently, it is demonstrated that the optical properties of these AlyTi1−y(OxN1−x) deposited films can be controlled in a wide range from metallic to dielectric character by adjusting the oxygen concentration, opening a huge range of possibilities for the design of solar selective coatings (SSC) based on this material.
The present results will open a way to design desired stable negative temperature coefficient thermistors by adjusting the annealing oxygen atmosphere of films.
Therefore, it can be concluded that by adjusting the amount of oxygen in the WG of the sputtering process the phase composition, optical behavior, and structure of the copper thin films can be controlled.
By adjusting the amounts of oxygen, nitrogen, and fuel, both the maximum measured flame temperature and the spatial profile of the temperature were kept nearly constant as the equivalence ratio was varied.
Except choosing the oxide materials with small oxygen diffusion coefficient as buffer layers in coated conductors, the degree of oxidation about NiW substrate could be greatly controlled and it would result in the less destruction of texture and structure of buffer layers by adjusting the annealing temperature, oxygen partial pressure and dwelling time in the process of YBCO deposition.
According to the HR relation, the THz reflectance of the ITO film is mainly affected by the conductivity which can be controlled by adjusting the annealing temperature and the oxygen flow in the process of preparation.
