The projection in Figure 4C shows that the clone initiated by a single plated mDEL1 mutant cell cannot reach the population size required for visibility (10) within the experimental period.
The double auxotrophic mutants could be determined by growth on only a single plate and an alternative requirement by growth on more than two plates.
At each step of antibiotic selection we pooled a few hundred colonies from a single plate, by adding five ml of LB broth to the surface of the plate, scraping the cells into the LB broth, and resuspending the cells by pipeting.
A 35% reduction in liquid flux was observed by using a single plate-foam riser assembly in a foam stabilised by 0.52 g/L sodium dodecyl sulphate solution, and the liquid rejected from the foam due to the presence of the foam riser had the same concentration as the feed solution.
This comparative study was conducted to systematically investigate the corrosion resistance and lubricated sliding wear behavior of graded Ni P alloy deposits produced from a single plating bath by electrodeposition and hard Cr deposits, using potentiodynamic polarization and reciprocating ball-on-disc tribometer.
It is seen that for all practical cases such two movable plate designs can be represented by a single movable plate with equivalent membrane parameters.
The procedure is used to simulate the breakup of coherent eddies by a single flat plate embedded in a viscous boundary layer.
For long-term storage, vegetative stock cultures (OD600 of 0.4-0.6 0.4-0.6repared and stored at −80°C in 10% glycerol by inoculating a single sporulated plate colony into 10 ml 2×YTG and heat shocking at 80°C for 10 minutes to induce germination.
This paper described the initial form of such a model, which is based on the sound radiated by a single, flat, elastic plate under boundary layer excitation.
While both models are based on the Kirchoff hypothesis and on the nonlinear Föppl von Kármán (FvK) strain-displacements relations, the second model employs the Berger approximation, which significantly simplifies the formulation and describes the plate by a single governing equation.
