Sentence examples for but the corresponding values from inspiring English sources

The two cattle breeds were not different in their dry matter intake per body weight (or metabolic body weight) and digestibility, but the corresponding values for the oil plant dietary treatments were less (P<0.001) than those for the control diet.

This saving might be acceptable, but the corresponding values for longer warranties are lower.

Each of the three single mutations from an acidic residue (E) to a neutral one (S) leads to an increase in Tm of between 4 and 5 °C, but the corresponding values for Tc decrease by amounts of 13 14 °C, that is, approximately three times as much.

According to another report, the probability of success at 120, 240 and 360 days after combined preoperative IVB and trabeculectomy was 87.5%, 79.2%, and 65.2%, respectively, but the corresponding values after only trabeculectomy without IVB were 75.0%, 71.9%, and 65.3%, respectively [ 20].

Total gas production after 2, 4, and 8 h incubation was higher (P < 0.01) in the FRS treatments but thereafter the corresponding values were lower for FRS (Table 5).

Such a threshold was observed also for 1-keV Ar+ bombardment of InP [39], but the corresponding value of f was somewhat lower (approximately 3.6 × 1014 cm−2 s−1).

The result is not shown here, but the corresponding value of λ is about 2.7.

Thus, the IC50 by phenformin was 2.5 mmol/l, but the corresponding value for metformin was 275 mmol/l far higher even than the non-specific cation tetramethylammonium [ 22].

The plasma level of PTX3 in control subjects (37 males, 27 females, mean age: 76 ± 9 years) was 2.58 ± 0.53 ng/mL, but the corresponding value was 3.42 ± 0.88 ng/mL in the CHF patients (220 males, 157 females, mean age: 77 ± 9 years).

The k values for the commercial PLA was significantly higher during early degradation but relatively similar to the corresponding values for the PLLA material during later degradation (14 91 days).

The dn/dc of the adsorbed C3Ms cannot be measured directly but has to be estimated from the corresponding values measured in solution.