Sentence examples for bulk heating rate from inspiring English sources

We show that although microwave selective heating can increase the yield and quality of the polyphenols extracted, if the same bulk heating rate is applied there is no difference in treatment time and therefore theoretical energy requirements of the process.

This reasonable assumption can explain the overall increase in the hydrolysis rate without simultaneous bulk heating.

The effects of coal fly ash additions, foaming time, heating rate and sintering temperature on the bulk density, porosity, mechanical properties and thermal conductivity were systematically investigated.

However, wire antennas with a smaller bulk volume are preferable over planar antennas for a faster heating rate which lead to a lower thermal response time [28].

From the above results, it was determined that CoQ10 loaded in the LNCs was likely in the supercooled state when the particle size of CoQ10-LNCs reached or dropped below 200 nm. Figure 1 DSC heating and cooling curves of bulk materials and CoQ10-LNCS from −60°C to 60°C at a heating rate 5°C/min and cooled from 60°C to −60°C at a rate 5°C/min.

The final mass depended on the heating rate as well as on the initial mass and bulk density and was reproducible when these parameters were carefully controlled.

To investigate the thermal stability, porous transparent bulk TiO2 was heated at different temperatures for 2 h with a heating rate of 5 °C/min in air.

Measurements at the most suitable heating rate indicate that the thermal stability of the crystals is higher for nanofibres compared to bulk material.

However, the heating rate of an antenna decreases with the increase of its gain bandwidth product due to increased bulk volume.

Heating rate is 10°C/minn.

Heating rate was 10°C·min−1.