Sentence examples for bulk density of about from inspiring English sources

A common commercial form has a bulk density of about 0.7 gram per millilitre and a surface area of about 750 square metres per gram, more than five acres per ounce.

The Al-waste content in the resultant geopolymer at 40 wt% cured at 80 °C showed the highest compressive strength of about 40 MPa and also the highest bulk density of about 2.8 g/cm3.

The FS samples are black powder, insoluble with the bulk density of about 0.25 g/cm3 and the fullerene content of about 10%.

Approximately 7 kg of moist (20%% volumetric water content) soil were used to give a dry bulk density of about 1.1 kg l−1.

Compressed earth blocks (CEB) were used for the construction, always and until now systematically with a bulk density of about 1800 and 2100 kg m−3.

The paper presents a two-step method for obtaining sodium tripolyphosphate (STPP) with a bulk density of about 0.90 kg/dm3 after the first step, using sodium phosphates after spray drying and water as the raw materials.

Moreover, increasing bulk density of the composite PCM can bring about a shorter thermal energy storage time.

The bulk density of the material was about l 010 kg/m3 and the particle density 2350 kg/m3.

Because of the low bulk density of cellulose, concentrations greater than about 5% become very thick and since cellulose is insoluble, the effective concentration is the available surface.

Earlier inversion results suggested a bulk density variation of about 250 kg m−3 (Schill et al. [2010]).

The bulk density of the three monodisperse materials was about 2.6 g/cm3, and thus the total volume of the polydisperse materials used in each test remained nearly the same.