Sentence examples for buffer were injected at from inspiring English sources

The recombinant CD40 GST fusion proteins in HBS-EP buffer were injected at a flow rate of 10 µL/min, followed by ASKP1240 at concentrations of 0.16 10 µg/mL (flow rate of 10 µL/min).

When 1 μL of a 10 μmol L−1 solution in buffer is injected at a flow rate of 1 μL min−1 (165 s exposure time), the injected protein is completely digested, as was observed with UV detection (data not shown).

To correct for refractive index changes caused by running buffer and instrument noise, running buffer was injected at a flow rate of 30  μl/min in the blank flow cells and the observed response difference was subtracted from the experimental data.

Mab dilutions in HBS-EP buffer were injected (20 μL at 20 μL/min) over the chip surface which resulted in OTA Mab complexes.

Subsequently, 20 mL of collagenase (100 μg/mL dissolved in D-hanks buffer) were injected.

Proteins in the reaction buffer were injected into the chamber to measure binding to DNA substrate.

MOs, diluted in Danieau buffer [16] were injected at the 1- to 2-cell stage.

Helicase samples (10 µM) were prepared in running buffer and were injected at 20 µl/min across the sensor surface.

The stimulant (epinephrine, 10 μM) and buffer (culture medium) were injected at 1 μL/min into the channel via a pump.

PBS buffer was injected into the tube at a speed of approximately 0.01 MPa/s (75 mm Hg/s) until failure.

Capped mRNAs were injected at 0.5-3 μg/μl in injection buffer (5 mM KCl, 10 mM NaH2PO4).