Sentence examples for buffer were chosen as from inspiring English sources
The initial content of methanol in the mobile phase, the gradient time, and the concentration and the pH value of the buffer were chosen as relevant experimental parameters.
Based on our initial trials, 0.5 ng of RPS24 MO and control MO, 20 umol/L miR-142-3p miR-142-3p miR-142-3py, Guangzhou, China), 2 ng miR-142-3p MO anduplexesl MO in Danieau's buffeRibore Companyas the optimal concentration, which showed siGuangzhou deChinae in O-staining signal, but no obvious morphological defects when compared with the control embryos.
The turbidity of IB resuspension in the solubilization buffer was chosen as the index to reflect the solubility of IBs, and lower turbidities were associated with higher IB solubilities [25],[25].
The results revealed that the peak current and sensitivity of the method do not change significantly with type and salt concentration and the phosphate buffer was chosen as the best electrolyte.
It was found that increasing the volume of 0.2 M borate buffer of pH 8.0 up to 2 mL resulted in a gradual increase in the fluorescence intensity of the reaction product and after which it remained constant till 3 mL, therefore 2.5 mL of the buffer was chosen as the optimal volume throughout the study.
The 10 km buffer was chosen as an easy to travel distance for fishers and a distance where reef habitats may be strongly influenced by land-based human disturbances, such as coastal development and pollution.
The unit concentration (0.1 μg mL−1 in this study) of α-actinin (A9776; Sigma-Aldrich, Sweden AB, Stockholm) dissolved in the low-salt buffer was chosen as the lowest concentration that would reduce the number of moving actin filaments.
Five hundred-meter buffers were chosen as the scale of analysis as these approximated a 5 10 min walk from the home and would capture the environment to which the participants are most exposed.
The 45%, 35 % and 5 sucrose in MES buffer were chosen to make a discontinuous sucrose gradient.
That was chosen as 'time 0'time
The standard parameters of the model were as follows: For the fixed endogenous Ca2+ buffer, the rates were chosen as kon = 5 10 M−1 s−1 and koff = 1000 s−1 (affinity 2 µM).
