Sentence examples for buffer length from inspiring English sources

Since only the above two schemes cannot provide the best system performance, to make the packet scheduling more flexible, many prior works have been carried out to select the most appropriate video presentation or even code the video source to match the time-varying channel states [7 10] or control the client buffer length [1].

Table 2 Simulation setup parameters Simulation parameter Value Simulator NS-2 (v.2.34) Simulation area 100 × 100 m Number of nodes (x) 40 Transmitter range 250 m Bandwidth 2.4 GHz Packet size 512 bytes Buffer length (MSa) 50 bytes Traffic type Constant bit rate (CBR) Simulation time 50 s Receiver energy (R x ) 28.1838 mJ Transmitter energy (T x ) 28.1838 mJ Initial energy (E i ) 500 mJ.

We note the frequency can be calculated as Fs/(Buffer length).

For the occurrence of concentrated overland flow, no practical buffer length may be sufficient.

NOTE: Timeouts are not necessary, since the chances that ek's Kermit partner can not time out are about 0. The EK 1.2 format puts k as the first argument for consistency with other routines, and adds a buffer length argument.

network_send_packet function takes two (buffer, length) pairs: one for the header, and one for the data; the buffers get concatenated before they're sent, and it's the receiver's job to strip the header off the packet when it arrives.

This non-linear relationship predicts comparatively longer buffer lengths at gentle slope gradients than guidelines/practices currently in use.

However, for large storms, steeper slopes, and/or more degraded conditions, buffer lengths greater than those predicted by the ESL criteria may be needed to minimize impacts from overland flow.

This idea could then be extended to writing probabilistic test benches to analyze the performance of different architectures as well as device and test arbitration policies which would attempt to optimize the power consumption and buffer lengths with constraints on the average delay.

Secondary formation of NO2 from NO might suggest longer buffer lengths, with one LUR study showing 300 m buffers to be effective [ 31] and one meta-analysis [ 30] indicating values of 200 500 m across studies.

In this case, assuming the samples are mutually independent, the fault missing rate of MSC-DM-CRC for a given buffered length N can be expressed as P m - MSC 2 n ± 1 = ( P m _ MIF 2 n ± 1 ) N, (15).