Sentence examples for buffer layer is a from inspiring English sources

Hence, stability of the buffer layer is a critical factor to bed-separation water burst.

The present findings suggest that an Au buffer layer is a good candidate for a barrier of interdiffusion between the catalyst layer and metal substrate for CNT synthesis.

Interfacial buffer layer is a primary requirement for highly efficient and stable organic solar cells (OSCs) and has become a significant part of OSC research today.

The preparation of a substitutional solid solution element diffusion zone with inverted-S elastic modulus distribution as a buffer layer is a certifiable and proper way to solve the load-bearing problem for a hard film on soft substrate system.

Introduction of strain in silicon using a SiGe buffer layer is a well-known technique to enhance carrier mobility [73], which was used by Intel for the first time in the 90 nm process technology [74].

The inductive measurements show the critical current density as high as 1.2 Matcm2 at 77 K in self-field, indicating that a GZO single buffer layer is a suitable alternative for simplifying the second generation high Tc superconducting coated conductors architecture.

The results indicate that the combination of the CuSCN anode buffer layer and PDINO cathode buffer layer is an effective way to get high photovoltaic performance of the p-i-n planar pero-SCs.

Metal oxide buffer layers are a promising method for improving the efficiency and stability of organic photovoltaic cells and organic light-emitting diodes.

After nitrifying HfO2 substrate at the temperature of 680°C for 20 min, a 150-nm thick buffer layer is deposited at a temperature of 680°C, and a 450-nm high-temperature GaN layer is then grown at the temperature of 750°C.

Subsequently, the temperature is ramped down to 485 °C, and the growth of the 300-nm-thick buffer layer is initiated at a growth rate of 1000 nm/h and a V III beam equivalent pressure (BEP) ratio of 7. The substrate temperature is ramped down by the end of the buffer layer and stabilized in order to ensure a stable substrate temperature of 450 °C during the W-QW growth.

The existence of the buffer layer is confirmed by a scratch made by tweezers as shown in the inset.