Sentence examples for broadening and decrease from inspiring English sources

By comparing the XRD patterns of MgH2 milled for 10 h and MgH2 containing 6 wt% of mischmetal milled for 10 h, a broadening and decrease in the peak intensities of the catalyst-containing sample can be observed.

The diffraction pattern of the Al2O3 thick film showed peak broadening and decreased intensity in comparison with that of the Al2O3 starting powder as shown in Figure 1a.

In addition, the tangential band of the external and internal tubes broaden and decrease in amplitude.

With the Sb spray time increased to 22.5 s, however, the InAs QD phonon peaks present broaden and decrease in intensity, with the peaks becoming less resolved.

However, estimating the number of QDs in a cluster using this histogram-based method is often challenging because intensity peaks in the histogram broaden and decrease with photooxidation and because the on-state intensities of QDs in the cluster may be different.

It was established that exposing the sample to CO2 leads to a slight blue shift of the absorption peak, band broadening, and a decrease in the maximum absorption level.

Upon binding to the protein, ligands relaxation time will decrease, causing a line broadening and a consequent decrease in intensity on their signals; finally, the water-ligand observed via gradient spectroscopy (WaterLOGSY) experiments apply a selective pulse to saturate resonances of water molecules.

Raw bagasse results presented on Figure  6 show only a slight spectral broadening and a net decrease of 10% in the mean decay time when the region close to the outermost interface of the fiber is compared to its middle region.

The average crystalline size of the films was calculated from X-ray line broadening and it is decreased from 3.2 to 1.6 nm for x=0 0.04 which was confirmed by SEM studies.

The average crystalline size was calculated from X-ray line broadening and it is decreased from 3.09 nm (CdS) to 2.81 nm (Cd0.96Cu0.04S) then started to increase which was confirmed by SEM studies.

The favored interaction of non-polar compounds with these surfaces results in peak broadening and tailing, thus decreasing resolution and sensitivity.