Bridge resistance was compensated in current-clamp mode.
The MR-TMD system, even when moderately reducing the critical joint stress amplitudes, can improve substantially the overall bridge fatigue resistance over the uncontrolled structure.
For our film ignition bridges, the resistance of the films are required to be controlled between 1 and 4 Ω, and hence, much smaller and even near-zero TCR in TaN films with low resistivity is favorable for the properties of the devices.
All of the enzymes maintained high sensitivity to 8-methyl-3′- AM P-dione. Thus, as reported previously for B. anthracis topoisomerase IV, mutations in amino acid residues predicted to anchor the water–metal ion bridge caused resistance that was quinolone-specific.
Therefore, it is considered to combine rGO with CNT to increase the interface with the polymer matrix while reducing the thermal interface resistance, bridging adjacent rGO with one-dimensional CNT to form a three-dimensional thermal conductivity network in order to enhance the heat transfer performance of composite materials [8].
In contrast, we suggest that in the low pore volume regime thick lamella walls and extensive transverse bridging exhibit marked resistance to buckling-induced instability and scaffolds undergo a global failure, which is manifested in the measured quasistatic compressive response as a sharp drop of stress beyond peak stress.
Bolometer, instrument for measuring radiation by means of the rise in temperature of a blackened metal strip in one of the arms of a resistance bridge.
Fasteners used on the bridge are normal resistance type.
A Linear Research LR-700 ac resistance bridge (Linear Research Inc., San Diego, CA, USA) operating at a frequency of 16 Hz was employed for resistance measurements.
This study shows that the proposed bridge has sufficient resistance against bending, compression, global buckling and is considered feasible.
