Sentence examples for brass surfaces from inspiring English sources

Monolayers of 3-mercaptopropyl trimethoxysilanee (MPTS) were grafted from ethanolic solution on electrochemically reduced brass surfaces.

The color of the micro-structured brass surfaces is certainly dependent on the width, depth, and period of the microstructures.

In this paper, we exhibit the colorizing of brass surfaces by forming femtosecond laser induced microstructures on the sample surfaces.

These superior tribological properties in hard water are attributed to a Ca-containing tribolayer formed on the steel and brass surfaces.

They suggested that silver electroless deposition (SED) is a suitable alternative method to cyanoacrylate fuming method for development of latent fingermarks on brass surfaces except for metals which are coated in a lacquer.

A variety of single colors such as brown, yellow, green, and black are introduced on brass surfaces by engineering periodic microgratings, microholes, and ring-shaped micro-patterns using Single Beam Direct Laser Writing (SBDLW) technique.

In a process similar to the one that causes water droplets to dance across a hot skillet, liquids are suspended above a superheated, ratcheted brass surface on a thin cushion of vapor.

Movies of the process can be seen at www.uoregon.edu/linke/dropletmovies/. FRANK O'CONNELL The brass surface is heated to well above the boiling point of the liquid, in the case of water droplets to about 600 to 840 degrees Fahrenheit.

For ratchet fabrication, a jig was used to angle the brass surface off the horizontal.

Based on the above requirement, brass surface was coated by carbon nano tubes.

Upon the solution treatment, Cu2S would be formed on the brass surface as a thin black layer.