Sentence examples for boundary element model is from inspiring English sources

A fully three-dimensional boundary element model is used.

To investigate the ground vibration isolation by wave impeding block (WIB) in saturated layered soils under vertical loading, an improved three-dimensional (3D) boundary element model is established for analyzing the soil-foundation-WIB interaction problem.

The numerical results have been found in very good agreement with those obtained by using other solution techniques by which the accuracy of the present boundary element model is demonstrated.

In this article, after verifying that the boundary element model is in good agreement with numerical results reported by other investigators, the effect of noise in the measurements on the identifiability is studied with respect to different design parameters of laminated composites using a wide set of numerical examples.

A dislocation-based boundary element model was used to simulate intergranular stress corrosion crack propagation in virtual microstructures.

A two-dimensional boundary element model was developed specifically to address to investigate the local steady-state thermal field in the near field of the pipeline.

Various electrode configurations were tested and a series of computer simulations based on a realistic head boundary element model were also performed in order to further validate the clinical findings.The improvement seen in source localization substantially decreases as the number of electrodes increases.

This boundary element model was used to investigate the effects of soil conductivities, well casing geometry, well casing resistivity, and the location of a current source on the current and potential distribution at the well casing.

The boundary element model was then used for the forward model calculation.

In the present study, a quantitative three-dimensional boundary element model has been developed which can be used to determine the geometry of acceptable surface defects and to predict rolling contact fatigue life.

In order to accommodate the new definitions, the connectivity of the boundary element model must be updated and constraint equations must be generated and introduced in the boundary element system of equations.