The uncoupling efficiency through the bottom face of the sensor device (opposite the TiO2 scattering spot) was measured with an integrating sphere.
At the bottom of the borehole, a sensor capsule was installed that included a three-component short-period velocity seismometer, a three-component accelerometer, and a two-component tiltmeter.
The tissue strips were banded between a needle at the bottom of the bath and the sensor, and immerged into Kreb's solution ventilated with gas mixed with 95% O2 and 5% CO2.
The SnO2 layer at the bottom was the heart of the sensor where the conductivity changes according to the concentration of the reductant gases.
It consists of a vessel made in silicon, platinum thin film heater deposited on to the bottom of the vessel and a temperature sensor.
Footswitches (Delsys Wireless Force Sensitive Resistors, Delsys, Boston, MA) were placed on the bottom of both feet (sensor on base of first toe and calcaneus, resp).
This includes the walls and the bottom of the chamber), the surface of the sensor (a), and also possible aqueous compartments that are outside the measured volume (i).
If all that seems fine and the mouse is still jumpy, check the sensor on the bottom of the device for dust or debris and clean it if needed.
The black bar at the bottom of the screen hides an ambient light sensor, but it can get in the way of notification cards which rise from the bottom.
To establish a calibration curve at each slide position, a device without the membrane was placed directly against the FOXY slide so that the bottom of the microchannel was the fluorescence oxygen sensor itself.
